Показать сообщение отдельно
Старый 30.04.2015, 15:36   Сообщение #445
maydayanthem
Новичок
 
Регистрация: 09.11.2011
Адрес: sk
Авто: megane
Сообщений: 6
Сказал(а) спасибо: 0
Поблагодарили 0 раз(а) в 0 сообщениях
По умолчанию

Цитата:
Сообщение от Alkab Посмотреть сообщение
maydayanthem, hi ! can you please explain...
I don´t have many photos. In principle. If you don´t have hands free, then your cables in doors are not "complete" - you need 2 more cables with 2 more connectors: 1 for antenna+ 1 for IR. You have to buy somewhere cables from hands free car + buy handles with antenas (I bought complete with IR sensors, I also connected them, but I think, this is not necessary).
So, you need 2 complete cables + 2 handles (left + right).
Handle on driver´s side contains an antenna + a black switch.
Handle on passenger´s side contains only an antenna.
You will see it, because from the handle goes cable with connector and it is possible to disassemble the handle (there is 1 small screw).
The handles on car without hands-free are one-piece part: it is not possible to disassemble it.
And then you have to disassemble the doors and change the cables and handles. I takes (both sides) 2 hours.
Then you have to activate it via clip following the guide in this topic.
That´s all. Good luck

Regards
Изображения
Тип файла: jpg handle left-1.jpg (22.5 Кб, 59 просмотров)
Тип файла: jpg handle right-1.jpg (65.4 Кб, 53 просмотров)
Тип файла: jpg mechanism-1.jpg (39.5 Кб, 53 просмотров)

Последний раз редактировалось maydayanthem; 30.04.2015 в 22:20.
maydayanthem вне форума   Вверх Ответить с цитированием