Система контроля давления шин

[Alkab]

maydayanthem, hi ! can you please explain with photos how to know if there are antennas in the the doors and what new cables are needed and mainly where to connect them ?

[maydayanthem]

Сообщение от Alkab

maydayanthem, hi ! can you please explain...

I don´t have many photos. In principle. If you don´t have hands free, then your cables in doors are not "complete" - you need 2 more cables with 2 more connectors: 1 for antenna+ 1 for IR. You have to buy somewhere cables from hands free car + buy handles with antenas (I bought complete with IR sensors, I also connected them, but I think, this is not necessary).
So, you need 2 complete cables + 2 handles (left + right).
Handle on driver´s side contains an antenna + a black switch.
Handle on passenger´s side contains only an antenna.
You will see it, because from the handle goes cable with connector and it is possible to disassemble the handle (there is 1 small screw).
The handles on car without hands-free are one-piece part: it is not possible to disassemble it.
And then you have to disassemble the doors and change the cables and handles. I takes (both sides) 2 hours.
Then you have to activate it via clip following the guide in this topic.
That´s all. Good luck

Regards